Laser Stratos Class Association Laser Stratos
Home About the Class Events Forum Community Hints & Tips Links Contact Us
Laser Stratos Class Association
 All Forums
 General Chat or Queries
 Technical
 Mast Bend

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert Email Insert CodeInsert QuoteInsert List
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

 
Check here to subscribe to this topic.
   

T O P I C    R E V I E W
NEILW Posted - 27 May 2011 : 19:45:11
Hello all,
Does any one know if the mast on a Stratos has any 'pre bend' ?
I have recently taken the mast down and noticed when the mast is lying on a flat surface that there appears to be a few degrees of bend around the goose neck area- is this suposed to be there or have I possibly induced this with too much rig tension and too much kicker?
Also, I would be keen to learn of any figures for mast top to transome is any one has any or even measured theirs for comparison.
Hope someone can help.
Thanks
Neil W Stratos 0312

Laser Stratos Class Association © 2000-20013 Laser Stratos Class Association Go To Top Of Page
This page was generated in 0.42 seconds. Powered By: Snitz Forums 2000 Version 3.4.07